Drill the holes for the plastic anchors.
Trim off its overhanging end with a utility knife.
Stick a pencil through the jamb's screw holes to mark the wall.
2, step Two / How to Install.Drive a 1-inch stainless steel pan-head screw into each hole.Adjust the jamb until it's flush against the wall.From the point on the threshold where the door will pivot, measure the distance to bath fixtures or any other potential obstacles that an outswing door might wales rugby win hit.Fit the panel into the base track.Shower, door, shower, door Overview, illustration by Gregory Nemec, planning Ahead.Shower, door, cut the Base Track to Length.
On the side of the shower opening that will support the door, hold a jamb piece against the wall so that its lower end fits into the base track.This bottom sweep is specifically designed for frameless shower doors with 3/8.Screw the jamb to the wall.Smooth the cut end with a file.Center the screws on the aluminum extrusions to avoid hitting the glass.Use a plastic mallet to avoid marring the walls.Attach the interior handle and tighten the setscrews.Measure the width of the shower opening in at least three places: threshold, up to 5 feet, and halfway in between.
Shower, door, mark Position of the Hinge-Side Jamb.
3, step Three / How to Install.